PRM-01 FAQ

Q: What transmitters and receivers are compatible with PRM-01?

A:Transmitters:AT10II/AT10/AT9S Pro/AT9S/AT9

     Receivers:R12DS/R9DS

Q: How to connect the receiver with PRM-01?

A: Take R9DS as an example and connect as below.

Q: Can the JST end of the LiPo battery connect to PRM-01?

A: If it’s a 1S LiPo battery, the JST end can be connected directly. If the battery is more than 1S, the balance end is essential to connect with PRM-01.

Q: What’s the telemetry voltage input range?

A: From 1S to 6S.

Q: Why does the signal tower on the transmitter screen disappear after connecting with PRM-01?

A: The signal tower on the transmitter screen (AT10II/AT10/AT9S Pro/AT9S/AT9) disappears after connecting with PRM-01. It’s probably because the connection to the PRM-01 is not good or the chip doesn’t function and needs to be repaired.

Q: I want to connect PRM-01 to the NiMH battery. Can I build a NiMH battery with a balance plug?

A: No. PRM-01 will detect the voltage of each cell one by one. The voltage of each cell cannot exceed 4.2V. So the battery may explode if there is any mistake when you build it.