NEW
NEW
NEW
NEW
NEW
NEW
NEW
NEW
GPS
NEW
NEW
NEW
NEW
NEW
NEW
R6F FAQ
Q:How to bind R6F to RadioLink transmitter?
A:
1. Put the transmitter and the receiver close to each other (about 50 centimeters) and power both on.
2. Switch on the transmitter and the LED of R6F will start flashing slowly.
3. There is a black binding button (ID SET) on the side of receiver. Press the button for more than 1 second and release, the LED will flash quickly, meaning binding process is ongoing.
4. When the LED stops flashing and is always on, binding is complete and there will be a signal tower shown on top of the screen of the transmitter.
Note If bind to transmitters without screen like T8S or T8FB, the always on LED means binding completed.
Q:Why the LED on R6F keeps flashing slowly?
A The slow flashing LED means binding doesn’t succeed or the signal gets lost after binding completes.
Q:What is the operating voltage range that R6F supports?
A: The operating voltage range of R6F is from 4.8V to 10V, supporting high voltage servo.
Q:What transmitters are compatible with R6F?
A:R6F is compatible with RadioLink RC6GS V2/RC4GS V2/RC6GS/RC4GS/T8FB/T8S.